Recent content by VE258

and here is the bike with OEM and CTX stand. like i said-i dropped the rear by just a little bit. maybe an inch or so. i don't remember.

resell value is just too low for NC in US.makes no sense to sell it for this low. for me the thing with motorcycles-if you don't have one-you will always want one, you will be actively looking on Craigslist,Instagram pictures etc..wasting your own time..when you have one-you have no time to...

if your bike is lowered by a lot ( i mean-you can't use OEM side stand at all (and off course you can forget about using centerstand) and not interested in welding- your next option would be side stand from honda CTX. it's exact same thing,but a bit shorter. i have one,but it didn't worked for...

Neodymium magnets a work ! :) those metal disks on sides holding this frame inside the window

you can also try to use 3M 9448A tissue pads. it's a double sided pad. when used properly-it can hold pretty much anything. you can put magnet on one side and stick other side to the top of the frunk. problem is-those Neodymium magnets rusts really quick. you will need some sort of protective...

i didn't read the whole thing. + 1 for Neodymium magnets. i think N52 is the strongest. you probably can glue them to the back of the lid with epoxy or something similar. make sure you do this with a right polarity,but i would test it first with somethng like masking tape, to see, if the bag...

here is one of many variations i've made from scraps back in 12-2013(?). it doesn't' have to be big or wide. size of a hand palm is more than enough paying $120 bucks for same thing? f*** it

if you mean like a bend it a little bit forward, then it's not that hard. with a heat gun, something to bend on (trash bin) for anyone,who dare to try -put aluminum foil on that surface. plexiglass won't stick to it. but if you overheat it-it would be disaster. you have to mount a heat gun...

looks familiar? :) i'm on single cylinder burgman! Bonita Springs,FL - YouTube

Naples,Bonita-my favored places in FL (and US!). i'm staying over there at my friend's house couple times a year. I hope you all will be well after this gigantic hurricane.

grab a mouse sander and shave the foam on the seat anyway you like it. then reattach the top skin back with a staple gun

didn't work for me. way too low. i need something in the middle between OEM and CTX's attaching\uploading pictures is a royal pain for 21 century website\forum.

Thanks Dlare! the one i've ordered from ebay comes with CTX's OEM spring DirtFlier- i made my own (see my previous posts here) long time ago and they worked very well (it's two pieces of metal with 2 holes in each,nothing special about it) but i don't like the position of the bike on side stand...

you are mind reader! Thanks for the info! i was looking at it, just couple days ago at procaliber website,comparing CTX and NC stands,and it looks like it would fit perfectly. my only concern was the switch, which looks a bit different from NC,but thanks for a conformation! ordering one now...