MtnBkr47
Member
I just needed a handguard for a few months per year to keep the wind off my fingers, so I purchased a low-cost online guard that had NC750 logo. I had to cut off the end section and sand to clear my large Madstadt windscreen. The guard was flimsy, so I drilled/tapped for an additional screw, which stiffened the guard significantly. However, it did not shield my fingers from the cold, so I 3D printed a cupped plastic piece for the bottom finger area in red ABS and attached it with epoxy and screws. That works OK. I also printed a larger Logo and secured it with epoxy. If anyone else has the same online version and wants to try at least part of this printed upgrade, the (4) STL files are available at:
https://www.printables.com/model/459390-nc750xd-motorcycle-handguard-mod
See attachment for details.
https://www.printables.com/model/459390-nc750xd-motorcycle-handguard-mod
See attachment for details.