tergin
New Member
Hi;
I've NC700D Integra 2012. When I bought it, it has a lowering kit. Two metal plates are longer than the original as you may know. Then I ordered the original plate cushion connection from the dealer with the exact code number 52471-MGS-D30 and replaced them with the lowering ones. Now my bike is in its original state with these plates. But this time, when I put the bike on the center stand, my rear tier only touches the ground, I cannot roll it for chain lubrication. Does anyone have NC700 DCT 2012 Integra can send a picture of the side stand with measurement in front of it? So I can check my center stand is standard state or it is also different from the original one.
Thanks
I've NC700D Integra 2012. When I bought it, it has a lowering kit. Two metal plates are longer than the original as you may know. Then I ordered the original plate cushion connection from the dealer with the exact code number 52471-MGS-D30 and replaced them with the lowering ones. Now my bike is in its original state with these plates. But this time, when I put the bike on the center stand, my rear tier only touches the ground, I cannot roll it for chain lubrication. Does anyone have NC700 DCT 2012 Integra can send a picture of the side stand with measurement in front of it? So I can check my center stand is standard state or it is also different from the original one.
Thanks
Last edited: