Craigmri
Member
Hey guys, I'm a neurotic engineer I admit it. I recently ordered the sub harness alond with the relay kit so I can power my GPS and frunk USB power outlets. Since I want these items switched I decided to stay with OEM instead of aftermarket solutions. The sub-harness comes with four accessory plugs. Three are one type and the fourth is different. I'm unclear what the fourth(square) connector is for. So I set out to find the corresponding connectors to plug in. Some have replaced the Honda supplied connectors with ones locally sourced but I figured it must be an available connector so I finally found them and placed my order.
The outfit is called Cycle terminal and here is the link:
Motorcycle 2.8mm - 110 Connector and Terminals
The ones I ordered were the fourth option down called 3 pin 2.8mm - .110 Male and Female locking connector
I believe the fourth(square) connector is the third option down called 4 pin 2.8mm - .110 Male and Female locking connector
Whats noteworthy and to avoid confusion, the connector called a 3-pin only has two conductors used(the middle one is empty on the Honda Side)
The 4-pin connector only has three conductors used(one is empty on the Honda side).
Hope this is useful to those that want to add accessories and not hack up the subharness you just paid good money for.
The outfit is called Cycle terminal and here is the link:
Motorcycle 2.8mm - 110 Connector and Terminals
The ones I ordered were the fourth option down called 3 pin 2.8mm - .110 Male and Female locking connector
I believe the fourth(square) connector is the third option down called 4 pin 2.8mm - .110 Male and Female locking connector
Whats noteworthy and to avoid confusion, the connector called a 3-pin only has two conductors used(the middle one is empty on the Honda Side)
The 4-pin connector only has three conductors used(one is empty on the Honda side).
Hope this is useful to those that want to add accessories and not hack up the subharness you just paid good money for.