use2b
Member
installed a center stand this week and realized i needed a stop due to exhaust change .
have seen a few different ideas but this is what i came up with that is out of the way and works well.
I used angle SS plate with two bolts , one of which is on the heavy duty clamp that came with my aftermarket exhaust.
I also used Steel putty to form the inside for fit and will sand the excess down and paint it black on the inside of the pipe and leave it color matched on the outside .
just sharing an Idea
have seen a few different ideas but this is what i came up with that is out of the way and works well.
I used angle SS plate with two bolts , one of which is on the heavy duty clamp that came with my aftermarket exhaust.
I also used Steel putty to form the inside for fit and will sand the excess down and paint it black on the inside of the pipe and leave it color matched on the outside .
just sharing an Idea