InfernoST
Active Member
Hi Gang
I've been experiencing handlebar wobble for quite a while now, I originally chalked it up to the OEM supplied front tire had become scalloped. I recently replaced the front and rear tires with a different set of new dunlops at about 9000 miles and am still experiencing this front end wobble everytime I take my hands off the bars, the front wheel has new tire new bearings, seals, is balanced and not bent (checked with a dial indicator) and runs true. I check the service manual and the information supplied doesn't specifically state how tight the neck bearings spanner nuts should be, I know it has to easy but when the bike is on the center stand and I put my weight on the back of the bike to raise the front wheel off of the ground with wheel facing straight ahead the bars flop to the right side rather quickly which I find very odd. I was concidering of adjusting the spanner nuts just enough to keep the bars from flopping to the right like that. My Bike info is as follows, 2020 NC750X fully manual transmission. Does anyone have any suggestions? FYI I have tried letting go of the bars with the topcase and side boxes removed, either way it's a pretty violent wobble.
I've been experiencing handlebar wobble for quite a while now, I originally chalked it up to the OEM supplied front tire had become scalloped. I recently replaced the front and rear tires with a different set of new dunlops at about 9000 miles and am still experiencing this front end wobble everytime I take my hands off the bars, the front wheel has new tire new bearings, seals, is balanced and not bent (checked with a dial indicator) and runs true. I check the service manual and the information supplied doesn't specifically state how tight the neck bearings spanner nuts should be, I know it has to easy but when the bike is on the center stand and I put my weight on the back of the bike to raise the front wheel off of the ground with wheel facing straight ahead the bars flop to the right side rather quickly which I find very odd. I was concidering of adjusting the spanner nuts just enough to keep the bars from flopping to the right like that. My Bike info is as follows, 2020 NC750X fully manual transmission. Does anyone have any suggestions? FYI I have tried letting go of the bars with the topcase and side boxes removed, either way it's a pretty violent wobble.