fleetingyouth
Active Member
Ok I changed my tail light yesterday and it was a huge pain cause of my custom tail tidy. I tested it several time with ignition on but not the motor running before puting the bike away. I just went out to take it for a ride and it wont start .
All lights work. Display comes on. If I hit the ignition I hear a click from the frunk. If I grab the brake the display goes out then comes back on. Also the front running lights flicker when I hit the ignition.
I'm guessing this is an electrical problem? I used the stock incadesent dual bulb as a replacement. No wiring has been changed from stock. The break light is working fine.
Ideas?
Thanks
All lights work. Display comes on. If I hit the ignition I hear a click from the frunk. If I grab the brake the display goes out then comes back on. Also the front running lights flicker when I hit the ignition.
I'm guessing this is an electrical problem? I used the stock incadesent dual bulb as a replacement. No wiring has been changed from stock. The break light is working fine.
Ideas?
Thanks