rpvanoyen
Member
I'm back...
Today I drilled two holes for the two main power wires and the eight outgoing wires. I wanted to have all through one hole but after a lot of pushing and pulling, it seemed too tight.
For extra protection (beside the rubber grommets) I used a piece of shrinking tube in the power intake, causing a tight fit and a great pull protection on the wires.
The thick bundle (?) also got a shrink tube (transparent) but after shrinking it would not fit anymore through the grommet, whether I jumped high or low (Dutch expression). So I had to remove the whole tubing, cutting it with a knive, very very careful. Unfortunately the blue wire got damaged so made a new one on the go.
Finally all wires are in and through and quite ready to connect to the components, which will be done tomorrow (my schedule is a stretched one ).
Just to keep you satisfied, a picture...
Today I drilled two holes for the two main power wires and the eight outgoing wires. I wanted to have all through one hole but after a lot of pushing and pulling, it seemed too tight.
For extra protection (beside the rubber grommets) I used a piece of shrinking tube in the power intake, causing a tight fit and a great pull protection on the wires.
The thick bundle (?) also got a shrink tube (transparent) but after shrinking it would not fit anymore through the grommet, whether I jumped high or low (Dutch expression). So I had to remove the whole tubing, cutting it with a knive, very very careful. Unfortunately the blue wire got damaged so made a new one on the go.
Finally all wires are in and through and quite ready to connect to the components, which will be done tomorrow (my schedule is a stretched one ).
Just to keep you satisfied, a picture...