Whiteknuckle
New Member
Got the NC in May of this year. My only real complaint was the wind noise. A painful ROAR mostly in my right ear. Wind itself does not bother me. I came from a naked Yamaha FZ07 and i had a 2014 NC750S (tiny screen) and was fine even at 160kph
I had been able to manage the noise for the most part by installing closed cell foam in the ear wells of my Shoei GT-Air. (always wear earplugs as well). I had considered a Maadstad screen. I did order one but ended up cancelling the order.
I would be happy with the stock screen if i could just raise it about an inch. In July i came across a bracket that turns the stock screen into an adjustable screen. It was sent on July 30. Finally arrived today. Got it installed. Looks great and had no problems
with the install. Have not tested it yet, hope to be able to this weekend.
i would link the website but they are closed for holiday until Aug 27 and website is "off". Just a message saying they are on holiday.
This is the link to the install instructions pdf in case you want to see what it looks like. I have it set to the half way point on the bracket. May have to experiment to find the best position. But half way seems to be about an inch taller than stock.
http://www.bruudtcnc.de/anleitungen/anleitung-winds-ncx2016.pdf
I had been able to manage the noise for the most part by installing closed cell foam in the ear wells of my Shoei GT-Air. (always wear earplugs as well). I had considered a Maadstad screen. I did order one but ended up cancelling the order.
I would be happy with the stock screen if i could just raise it about an inch. In July i came across a bracket that turns the stock screen into an adjustable screen. It was sent on July 30. Finally arrived today. Got it installed. Looks great and had no problems
with the install. Have not tested it yet, hope to be able to this weekend.
i would link the website but they are closed for holiday until Aug 27 and website is "off". Just a message saying they are on holiday.
This is the link to the install instructions pdf in case you want to see what it looks like. I have it set to the half way point on the bracket. May have to experiment to find the best position. But half way seems to be about an inch taller than stock.
http://www.bruudtcnc.de/anleitungen/anleitung-winds-ncx2016.pdf