NovaGeeze
Member
I'm away from my bike but designing and 3d-printing some accessory mounts.
Can anyone verify for me that this is a 5mm screw, and maybe the diameter of that pan head?
I'm tinkering with making a simple mount for that spot for my Oxford heated grip controller, and maybe one for my TP sensor system for the other side.
Trying to remember if the bars would foul that spot as well.
Oh, and another, if anyone's got one handy. I got the honda oil filter / wrench kit, and there's a nut on the top to allow for wrenching it off (at least that first, too-tight, factory-mounted one) and it had a threaded interior in order, I believe, to eject the filter when it gets stuck inside. (I banged one out with a rod last time around and it bent the nut on top, so I know that's the sub-optimal way to do this.) I'm thinking it's an M10 1.25 mm pitch, but if anyone's got that figured out, I'd appreciate a heads up there too.
Can anyone verify for me that this is a 5mm screw, and maybe the diameter of that pan head?
I'm tinkering with making a simple mount for that spot for my Oxford heated grip controller, and maybe one for my TP sensor system for the other side.
Trying to remember if the bars would foul that spot as well.
Oh, and another, if anyone's got one handy. I got the honda oil filter / wrench kit, and there's a nut on the top to allow for wrenching it off (at least that first, too-tight, factory-mounted one) and it had a threaded interior in order, I believe, to eject the filter when it gets stuck inside. (I banged one out with a rod last time around and it bent the nut on top, so I know that's the sub-optimal way to do this.) I'm thinking it's an M10 1.25 mm pitch, but if anyone's got that figured out, I'd appreciate a heads up there too.
Last edited: