VE258
New Member
Can one use side stad from S rather than dealing with cutting/welding original X side stand? Or they are same length?
Thank you!
Thank you!
Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature currently requires accessing the site using the built-in Safari browser.
We have a water-jet at work that I can have a buddy cut lowering links out of Stainless Steel plate.
Do you have any dimensional specs on the link you made. Specifically the distance between the center of the bolt holes.
I lowered mine a little over an inch. Then i bought a CTX700 side stand on eBay to replace the stock NC700 side stand.
The CTX700 stand is a little shorter and seems to give mine about the right amount of lean.
Dean
I used the NC spring.you are mind reader!
Thanks for the info!
i was looking at it, just couple days ago at procaliber website,comparing CTX and NC stands,and it looks like it would fit perfectly.
my only concern was the switch, which looks a bit different from NC,but thanks for a conformation! ordering one now.
what about spring? do i need one from CTX or spring from NC will work?
Thanks!